Monterey Bay Aquarium Research Institute
Education
Build Your Own Remotely Operated Vehicle

Step 11


Take the heavy duty speaker cable and cut off about ten inches to use later. Insert the long piece into the second hole in the bottom of the conduit box.

Separate the two wires by tearing them apart about 3-4 inches.

Strip the end of each wire about ΒΌ inch.

Attach a 16-14 AWG ring terminal to one of the wires and a female push on terminal to the other wire. Solder each of these connections.

Remove the screw from the right side of the toggle switch at the top of the triangle.

This terminal will already have a wire connected to it, but add the ring terminal and then re-attach the fork terminal and tighten the screw as shown.

Previous Step          Next Step

Last updated:February 6, 2009